 |
||||||||||||||||
|
||||||||||||||||
|
||||||||||||||||
 |
||||||||||||||||
|
|
|||
Direction for use |
|||
1. When you unlock, please make the dot of key facing the pattern of lock and insert it into the left and the right lock cores and turn it for 90 degrees. When you hear a “click”, you turn the key back to the original position then you can open the door; 2. When you lock the door, please pull all locking bolts (D) and make part of locking tongue pop up. Then you pull the door to the corresponding position of the lock hole, the locking tongue (A) will be locked automatically and you may hear a “click” as well. |
|||
 |
|||
SH-3 |
|||
 |
 |
||
|
SH-1/SH-2 |
|||
Installation of the locks of SH-1 type/SH2 type |
|||
1. For installation, you must keep the door has a same space between the guiding groove on the left and on the right. |
|||
Installation of the locks of SH-3 type |
|||
1. Install the lock on the left and the right ends of the door groove at any height. The dimension that the locking tongue enters the guiding groove lock hole is about 10-25mm. |
|||
 |
|||
